Assembly Info

Here are some simple steps to assemble the 200 Series hose and fittings.  Speedflow’s 200 Series hose-ends are made up of three components – the main body, the socket and the aluminium olive. You’ll need the following tools: 200 Series cutters Pliers Small screwdriver Lubricant Vice Vice jaws Open end spanner Step 1 Select the correct size hose for the fittings and measure to the desired length.  This can be cut using the 200 Series cutters.  (It can also be cut with a f...

Here are some simple steps to assemble the 400 Series hoses. You’ll need the following tools: 400 Series cutters Vice Vice jaws Vice jaw adapter (if assembling angled fitting) Liquid soap Hot water Step 1 Select the correct size hose for the fittings and measure to the desired length.  This can be cut using the 400 Series cutters. (It can also be cut using a sharp knife or blade.)  Make sure the cut is square and any residue is trimmed and cleaned. Step 2 Install the hose-end...

Here are some simple steps to install the 399 Series restrictors into a -3 or -4 hose-end. Step 1 Disconnect your hose-end from the adapter.  Select the correct size restrictor: -3 (399-03) -4 (399-04) Step 2 Take the restrictor and insert into the hose-end until it seats.  Take care that it doesn’t fall out. Step 3 Connect the hose-end back to the adapter and tighten as per normal.  The hose is now ready to use with the 1mm restrictor.

Here are some simple steps to help you assemble braided hose and fittings. You’ll need the following tools: 100 Series cutters Tape Vice Vice jaws Lubricant Open end spanner Step 1 Select the correct size hose for the fittings and measure the length.  This can be cut using the 100 Series cutters.  (It can also be cut with a fine tooth hacksaw or a cut-off blade.)  Wrap the hose with tape and make sure the cut it square and any residue is trimmed and cleaned. Step 2 Remove t...